120430
28
All brands and logos are registered trademarks of their respective owners
POWER MANAGEMENT SYSTEM - LAN
On the
LAN settings
page (see Figure 10 above) you can set up
DHCP, IP address, Subnet mask, Gateway, DNS server and IP
filter (up to 3 IP addresses can then be enabled for remote
access). The new settings will be applied immediately after you
press the
Apply
button.
IP address, Subnet mask, Gateway, DNS server
will be used only
if the
DHCP
option is disabled.
If you set
DHCP
option it is recommended for your own
convenience to set up your DHCP server so that it always
provides the same IP address to PMS-LAN. To do that you will
need to know the MAC address of PMS-LAN. It can be found on
this page or on the bottom sticker of the device. The MAC address
is fixed and cannot be changed.
DNS server address
is important to be properly set up in case you
wish to enable the NTP timer correction option (see section 4.6
below).
IP filter
option is needed to prevent unauthorized access to the
server. It restricts the web server access from any computer with
IP address different from IP1, IP2 and IP3. Make sure that you
input IP1, IP2, and IP3 correctly before enabling this option.
