120430
12
All brands and logos are registered trademarks of their respective owners
POWER MANAGEMENT SYSTEM - LAN
Note:
If the total power consumption (or peak power) of the
devices, connected to the PMS-LAN exceeds 3 kWatts, the
circuit breaker will automatically disconnect the PMS-LAN from
the mains supply. Remove the excessive load and then press
the Circuit breaker button to restore the power supply (Figure 2
above).
To be able to use PMS-LAN you will now have to complete its
LAN configuration.
3.2.
Obtaining an IP address.
Option A
– via connection to the LAN (recommended)
Make sure the PMS-LAN is connected to the local network with
the RJ-45 patch cable.
Note:
by default the factory setting of PMS-LAN is DHCP enabled. If
your LAN has a router with built-in DHCP server (which is very
common) then PMS-LAN will automatically get an IP address from the
DHCP server. Proceed to section 3.3 below in this case.
Option B
– via connection to the managing computer
