Endress+Hauser Proline t-mass B 150, Краткое руководство по эксплуатации

Страница: 5 / 40

Proline t-mass B 150 Basic safety instructions
Hauser 5
2 Basic safety instructions
2.1 Requirements for the personnel
The personnel must fulfill the following requirements for its tasks:
►
Trained, qualified specialists must have a relevant qualification for this specific function and
task
►
Are authorized by the plant owner/operator
►
Are familiar with federal/national regulations
►
Before beginning work, the specialist staff must have read and understood the instructions in
the Operating Instructions and supplementary documentation as well as in the certificates
(depending on the application)
►
Following instructions and basic conditions
2.2 Designated use
Application and media
The measuring device described in these Instructions is intended only for flow measurement of
gases.
To ensure that the measuring device remains in proper condition for the operation time:
►
Only use the measuring device in full compliance with the data on the nameplate and the
general conditions listed in the Operating Instructions and supplementary documentation.
►
Based on the nameplate, check whether the ordered device is permitted for the intended use
in the hazardous area (e.g. explosion protection, pressure vessel safety).
►
Use the measuring device only for media against which the process-wetted materials are
adequately resistant.
Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
If the sensor gland is opened, the accuracy specifications of the measuring device no longer apply.
In such situations, the measuring device must be removed and returned for recalibration and to
the manufacturer.
฀
WARNING
Risk of injury if the process connection and sensor gland are opened under pressure.
►
The process connection and the sensor gland should only be opened in an unpressurized state.
NOTICE
Dust and moisture can enter the transmitter when the transmitter housing is opened.
►
Only open the transmitter housing briefly, ensuring that no dust or moisture enters the
housing.
NOTICE
Danger of breakage of the sensor due to corrosive or abrasive fluids
►
Verify the compatibility of the process fluid with the sensor material.
►
Ensure the resistance of all fluid-wetted materials in the process.
►
Observe the specified maximum process pressure.