Endress+Hauser Proline Promass 80S, Техническая информация

Страница: 20 / 54

Proline Promass 80S, 83S
20 Hauser
Note!
In case a danger of measuring tube failure exists due to process characteristics, e.g. with corrosive
process fluids, we recommend the use of sensors whose secondary containment is equipped with
special pressure monitoring connections (ordering option). With the help of these connections, fluid
collected in the secondary containment in the event of tube failure can be bled off. This is especially
important in high pressure gas applications. These connections can also be used for gas circulation
and/or gas detection (dimensions →  24).
Do not open the purge connections unless the containment can be filled immediately with a dry inert
gas. Use only low gauge pressure to purge. Maximum pressure: 5 bar (72.5 psi).
If a device equipped with purge connections is connected to the purge system, the maximum pressure
rating is defined by the purge system itself or the device, whichever is lower.
Pressure-temperature rating The following pressure-temperature ratings refer to the entire sensor and not just the process
connection.
Flange according to EN 1092-1 (DIN 2501)
Flange material: 1.4404 (F316/F316L)
A0020965-EN
Flange according to ASME B16.5
Flange material: 1.4404 (F316/F316L)
A0020966-EN
PN 40
PN 63
300 [°F] 350 250 200 150 100 50 0 -50
[°C] 200 150 100 50 0 -50
400
0
10
20
30
40
50
70
60
[bar] [psi]
200
400
600
800
0
1000
[bar] [psi]
Class 150
Class 300
300 [°F] 350 250 200 150 100 50 0 -50
[°C] 200 150 100 50 0 -50
400
0
10
20
30
40
50
60
200
400
600
800
0