Endress+Hauser Liquiline System CAT860, Руководство по эксплуатации

Страница: 27 / 44

Liquiline System CAT860 Operation
Hauser
27
9 Operation
The sample preparation menu is configured via the display and operating elements of a Liquiline
System CA80 analyzer. The status and the current process step of the Liquiline System CAT860
sample preparation system are also displayed here. For further information please refer to the
relevant documentation.
To ensure the optimum synchronization of the measuring point, all the components (analyzer,
sensors, sample preparation system) are controlled in automatic mode by the Liquiline System
CA80 analyzer. If key 1 on the Liquiline System CAT860 is pressed, this causes a request to
activate the onsite mode. If this conflicts with a program cycle that has already begun, the
system waits until the cycle is finished before the necessary activation is performed.
This process can take a few minutes, and sometimes even up to 30 minutes (e.g. if cleaning
the sample preparation system). Status LED 1 flashes during this time.
10 Diagnostics and troubleshooting
The Liquiline System CAT860 sample preparation system with Memosens technology supports
the user with diagnostic messages when diagnosing and rectifying faults as per NAMUR NE
107. The relevant diagnostic message is output on the Liquiline System analyzer display.
If an error category "F" diagnosis message occurs, the status LED of the Liquiline System CAT860
is lit red and the display background of the Liquiline System CA80 changes to red.
--> Additional information is provided in BA01240C