Maintenance and cleaning
CE 4
18
Hauser
7.3
Operating the cleaning system
Depending on the device configuration the following possibilities are available for
manual or automatic cleaning of the pipework:
7.3.1
Manual cleaning using fresh water
When using the manual cleaning process the analysis pipework is rinsed, the suction
hoses are purged and the sensors are cleaned using a sprayhead and clean water. The
control of the cleaning system is done by manually operating a ball valve. the pump
must be switched off when purging the suction hoses.
Fig. 9:
Connection schematic for manual cleaning using clear water
7.3.2
Automatic fresh water cleaning system
Cleans the analysis pipework, purge the suction hose and cleans the sensors using a
spay head and clean water. Control is provided by a small integrated
controller. The cleaning cycles and length can be individually set up (
→
Chap. 7.3.4).
The cleaning sequence can also be started manually (pushbutton on the swing frame).
If the sensors are to be cleaned manually, then the pump must be switched on.
Fig. 10:
Connection schematic for automatic cleaning using clean water
Clean water
2 to 4 bar
Pump
suction hose
Sensor
spray heads
Site w
o
rk
CE 4
Clean water
2 to 4 bar
Pump
suction hose
Sensor
spray heads
Site w
o
rk
CE 4
Controller
