Empire Comfort Systems MILLIVOLT DVCD32FP30, Руководство по установке, Страница: 14 / 96

38712-2-0719 Page 14
JUnction boX Wiring (for optional bloWer)
caUtion
All wiring should be done by a qualified electrician and shall
be in compliance with all local, city and state building codes.
before making the electrical connection, make sure that the
main power supply is disconnected. The fireplace, when
installed, must be electrically grounded in accordance with
local codes or, in the absence of local codes, with the National
electrical code ansi/nfpa 70 (latest edition).
A factory installed junction box is located on the lower right
side of the fireplace. Wiring must be fed to the junction box and
attached to the receptacle that is provided. Leave approximately
six inches of wire in the junction box for connection.
Attach black wire to one side of the receptacle and white wire to
opposite side of receptacle. The ground wire should be attached
to the green (ground) screw.
Install the receptacle into the junction box. Attach cover plate.
standard millivolt valve models
figure 15
installation
The fireplace can be mounted on any of the following surfaces:
1. A flat, hard combustible (burnable) surface.
2. A raised wooden platform.
3. Four corner supports. (example: Four concrete masonry
blocks.) These supports must be positioned so they contact
all four perimeter edges on the bottom of the fireplace, if
allowed by local codes.
NOTICE: Verify the gas supply and electrical considerations
before beginning the framing.
framing information
Fireplace framing can be built before or after the fireplace is set
in place. Posistion framing to accommodate wall covering and
fireplace facing material. Construct the fireplace framing with
2 x 4 lumber or heavier. The framing headers or top plate may
rest on the fireplace standoffs. Refer to figure 16 for minimum
framing dimensions.
caUtion
Before construction begins, measure fireplace dimensions
and verify framing methods and wall covering details.
HEADER
dimensions (in inches)
dvcd32 dvcd36 dvcd42
A 39 39 41
B 35-1/4 38-1/4 44-1/4
c 18 18 18
figure 16