Emotiva BASX MC1, Руководство пользователя

Страница: 13 / 48

Page 7
BasX MC1 Cinema Processor
Getting Started
To get the most from your MC1 we urge you to read the entire manual.
If you cannot wait to listen to some music or watch a few movies, there are only a few things you
really need to do in order to get started, but we do suggest that you at least read all of this Getting
Started section so you don’t miss anything important.
1.
Find a secure location for your BasX MC1.
2. Connect your MC1 to your amplifiers and speakers. The MC1 supports surround sound
systems with up to 13.2 channels, but you can start with a simpler 5.1 or 7.1 channel
configuration, or even a simple two channel setup.
3. Connect your MC1 to your powered subwoofer if you have one. The MC1 will normally
handle Bass Management so, if you have a choice, use the LFE or line level input on your
sub, and bypass your sub’s crossover, or set it to its highest frequency.
Note: The MC1 has a Subsonic Filter that, by default, will block all frequencies below
approximately 20 Hz from reaching your subwoofer. If you wish to disable this you will
find it under Crossover settings in the Speaker Setup menu.
4. Connect your MC1 to your projector or TV set. The MC1 has two HDMI outputs, both of
which deliver the same HDMI signal, but only HDMI Output #1 supports eARC.
5. Connect some high quality video and / or audio sources to your MC1.
6. Make sure to have your TV or projector set to the correct HDMI input.
7. Configure your MC1 for the speakers you have connected. You will find these settings in
the Menu under Setup | Speaker Setup.
• Select your speaker setup and how many speakers you have under Speaker Layout.
Note: If you have a two channel system, select 3.1 as your Speaker Layout, and set
Center to None. If you don’t have a subwoofer, select the appropriate Speaker Layout for your
other speakers, then set Subwoofer to None.
• Select whether your height speakers are Reflective or Ceiling mounted speakers under
Height SPKR Type. Select Ceiling if you have direct radiating height speakers mounted
high on the wall.
• Configure the Distance to each speaker from your primary listening position. If you
have a large seating area then set the distance from each speaker to the center of your
listening area. If your room is more or less symmetrical then it’s best to also arrange your
speakers symmetrically.
Note: The distance value will move by one inch each time you press the button; if you hold the
button down the value will jump by feet.