EMobility eClick, Руководство по установке

Страница: 70 / 540

70
eClick installation instructions
Disposal
The eClick and the eBox are electrical equipment. These
must be disposed of accordingly in compliance with the
EU Directive WEEE II, the ElektroG of 20 October 2015
in Germany, or the VREG, SR 814.620, of 14 January 1998
in Switzerland.
Dismounting
The eClick must be dismounted by a qualified electrician.
Before dismounting the eBox, you must first disconnect it
from the voltage supply. First loosen the two grub screws
on the side and then. take the eBox out of the eClick by
pulling down the locking bracket, taking out the charging
unit, and, if fitted, detaching the Ethernet cable connecting
the eBox and the eClick. Now remove the contact guard
from the eClick, and detach the supply cable and, if fitted,
the Ethernet cable to the local network. Unscrew the cable
gland(s), and remove the supply cable and, if fitted, the
Ethernet cable(s). In the next step, unscrew and remove
the eClick. Finally, you may dismount the eSmartMeter
and replace the contact guard. Dismounting the ePoleDuo
is described in its installation instructions.
Caution
When disassembling the eBox,
make sure that the eBox is
carefully removed from the eClick
so that the flat ribbon data cables,
the eClick and the eBox are not
damaged during disassembly.
Caution
Make sure that all components
are dry during disassembly.
Danger
The eClick must be disconnected
from the power supply before
disassembly.