EMobility eClick, Руководство по установке

Страница: 59 / 540

59
Installation
Scenario A: single power supply line to the eClick without
eSmartMeter
Strip a generous length of insulation from the cable before
inserting it in the eClick: This will simplify rerouting and
the later installation of the eSmartMeter.
Introduce the supply cable into the eClick from the top
(T) or the bottom (B). Now place the wires on the
contacts as depicted in the figure, and tighten the screws
on the terminals with a torque of 1,2 - 1,5 Nm.
B
T
N L
1 L
*
Caution
If single-phase connection is required,
the mainboard or eSmartMeters must
not be connected to L2 or L3! The supply
line L1 must always be connected to L1 of
the mainboard or eSmartMeter.