Emerson Fisher FIELDVUE DVC6000, Инструкция по эксплуатации

Страница: 35 / 162

Installation
September 2013 2-13
FEEDBACK ARM
BIAS SPRING
TRAVEL
INDICATOR PIN
48B4164-B / DOC
HOLE A
HOLE B
Figure 2-11. Positioning Travel Indicator Pin in the Feedback Arm
(Viewed as if Looking from the FIELDVUE DVC6030 toward the
Actuator)
DVC6005 Base Unit
For remote-mounted digital valve controllers, the
DVC6005 base unit ships separately from the control
valve and does not include tubing, fittings or wiring.
See the instructions that come with the mounting kit
for detailed information on mounting the base unit to a
specific actuator model.
For remote-mounted instruments, mount the DVC6005
base unit on a 50.8 mm (2-inch) pipestand or wall. The
included bracket is used for either mounting method.
Wall Mounting
Refer to figures 2-12 and 2-13. Drill two holes in the
wall using the dimensions shown in figure 2-12. Attach
the mounting bracket to the base unit using four
spacers and 25.4 mm (1-inch) 1/4-20 hex head
screws. Attach the base unit to the wall using suitable
screws or bolts.
Pipestand Mounting
Refer to figure 2-13. Position a standoff on the back of
the base unit. Using two 101.6 mm (4-inch) 1/4-20 hex
head screws loosely attach the base unit to the
pipestand with the mounting bracket. Position the
second standoff, then using the remaining 101.6 mm
(4-inch) hex head screws, securely fasten the base
unit to the pipe stand.
10C1796-A / Doc
Figure 2-12. FIELDVUE DVC6005 Base Unit with Mounting
Bracket (Rear View)
DVC6015 on Sliding-Stem Actuators Up
to 102 mm (4 Inches) of Travel
If ordered as part of a control valve assembly, the
factory mounts the remote feedback unit on the
actuator, makes pneumatic connections to the
actuator, sets up, and calibrates the instrument. If you
purchased the remote feedback unit, you will need a
mounting kit to mount the remote feedback unit on the
actuator. See the instructions that come with the
mounting kit for detailed information on mounting the
remote feedback unit to a specific actuator model.
Note
Refer to the DVC6005 Base Unit
mounting instructions for off-actuator
mounting instructions.
The DVC6015 remote feedback unit mounts on
sliding-stem actuators with up to 102 mm (4-inch)
travel. Figure 2-1 shows a typical mounting on an
actuator with up to 51 mm (2 inch) travel. Figure 2-2
shows a typical mounting on actuators with 51 to 102
mm (2 to 4 inch) travel. For actuators with greater than
102 mm (4 inch) travel, see the guidelines for
mounting a DVC6025 remote feedback unit.
2