EMBRON Hatteland Technology HTC03 AC Series, Руководство пользователя

Страница: 37 / 150

User Controls / Physical Connections
37
IND100133-79
1 x AC Power INPUT (For units supporting AC input):
The internal AC power module supports 100-240V AC - 50Hz/60Hz using a standard IEC European power plug. See
specifications for more information.
1 x DC Power INPUT (For units supporting AC+DC inputs):
Connect your DC power cable to the 2-pin Terminal Block 5.08 connector. The internal DC power module supports
24VDC. For more information, please review “Housing Connector Overview” earlier in this manual.
GROUNDING SCREW:
Please review “General Installation Chapter”, pt. 6 for more information.
Note for Grounding Screws:Standard Grounding Screw/Bolt provided by Hatteland Technology is “Pan head screws
M4x8mm w/spring and plainwasher”.
Multi-power note: (For units supporting AC & DC input simultaneously)
The unit has a dual input power supply which will accept both AC and DC input. If both inputs are connected, the unit will be
powered by AC. If AC is disconnected it will automatically switch over to DC without affecting the operation of the unit. This makes
it possible to use AC power as primary power and a 24V battery as secondary power, eliminating the need for expensive UPS
systems.
1 x COM (RS-232/422/485) Serial Port INPUT/OUTPUT:
Supports RS-232 or RS-485/422 using D-SUB 9P connector (male) connectors. Fasten the cable to the connector
using the provided screws on the cable housing itself. For configuration, please review the Appendix chapter, section
“BIOS - On-board COM Ports Configuration”.
2 x DisplayPort (DP) OUTPUT:
Connect your DP (male) cable to the DisplayPort (v1.2) 20P connector (female) on the rear side of the unit. The DP
has its own locking mechanism that locks the plug inserted. Make sure the plug “clicks” into place to verify a proper
and secure connection. Additionally to add extra security, a Screw Lock in the chassis above the DP port is available if
your DP cable supports it.
Note: Signal Output can be used together with additional graphics card installed in one of the PCIe slots. Please
review Appendix Chapter “BIOS - Hybrid Multi Monitor Configuration”. Both active and passive DP to DVI adapters are
supported. For setups requiring three DVI-D outputs, an active DP to DVI adapter must be used. Passive adapter can
only be used for setups with max two DVI-D signals.