EMBRON Hatteland Technology HTC03 AC Series, Руководство пользователя

Страница: 23 / 150

23
IND100210-54
General Installation Recommendations
Installation
Installing PCIe Card / Rework PCI Bracket Options - Notice
All factory options are done in-house by our production facility prior to delivery. If you however need to install your
own PCI/PCIe cards later and any of the PCI Bracket Options are already pre-installed, please review:
“Physical Connections/ Added functionality through 4 x PCI Sized Metal Brackets”
chapter later in this manual.
As this is just a pre-installation notice, please review also the next following page regarding PCI/PCIe card
installation. Procedure applies for all HTC03 models.
Note: Areas of interest are marked in this section with RED color. Please disconnect ALL cables from the computer
unit before proceeding!
1: Identify if either of the PCI Bracket Options are
present in any of the slots (as indicated). If yes,
proceeed to step 2,3,4. If no, please proceed to next
page in this manual.
2: Observe the tie wrap and positioning of cables.
You may have to cut the tie-wrap that holds the cable to
the inner chassis, in order to insert the new PCIe card and
fit the cable again.
3: Either move the PCI Bracket Option into any of the
other free slots, or make sure the original cables are
routed under the PCIe card when you install the new
PCIe card (depending on which slot you have to use).
4: After installing the PCIe card, observe that the PCI
Bracket Options cables are not damaged, loose or are
subject for getting damaged after long use. Notice also
some PCIe card components may get hot. If possible, add
a tie wrap to secure the cables further to keep clear of
potentional heat.