WOP-12ac-LR. Quick guide for FBWA configuration via web interface
6
•
•
•
•
•
•
2 WOP-12ac-LR configuration
2.1 Connecting an access point to PC
PoE technology is used to power the WOP-12ac-LR, allowing it to transfer power through a UTP cable. A PoE
injector is used to connect.
Connect the access point to the
«Data & Power»
connector of the injector, and the computer to the
«Data»
connector. Connect the injector to a 220V power supply.
2.2 Configuring computer network interface settings
Install the following network interface settings on the computer:
IP 192.168.1.5;
Subnet mask: 255.255.255.0;
Default gateway: 192.168.1.1.
2.3 Connection to the WOP-12ac-LR web interface
To connect to the web interface of the WOP-12ac-LR, enter the following to the URL bar of your browser:
192.168.1.10
In the window that appears, enter:
User Name:
admin
Password:
password
If the authorization page is not displayed after entering the device IP in the browser, check the IP address on the
PC and switch settings. If the configuration on the device has been changed (is not a default one), reset the device
to factory settings. To do this, press and hold the «F» button on the side panel of the device for 20 seconds, to
access the «F» button, you must first unscrew the process screw.
2.4 Firmware update:
Preliminary download the firmware file from
http://eltex-co.com/support/downloads/
computer. After obtaining the relevant firmware version, open the menu
«Maintenance»
,
«Upgrade»
tab and
perform the following:
