WOP-12ac-LR. Quick guide for FBWA configuration via web interface
31
•
•
•
•
•
•
5. To apply the new configuration, click the
«Apply»
button.
To configure the management VLAN in accordance with the example described in point 1, the following settings
must be performed:
Set the flag in the
«Enable management interface»
field;
In the
«Access Type»
field select
«Untagged»
;
In the
«Protocol»
field, select
«Static»
;
In the
«IP address»
field specify the IP address: 192.168.100.5;
In the
«Subnet mask»
field: 255.255.255.0;
In the
«Default gateway»
field: 192.168.100.1.
4.10 Connection monitoring
When the session established successfully, the
Power
indicator on the device will light green. You can also track
the uplift of a session in the
«Monitoring»
section of the
«Internet»
tab.
When the session is successfully established, the IP address received by the device should be displayed in the
corresponding column (the figure below shows the state in which the address was not received).
If the device does not receive the address in the provider's internal network (fourth line), this means that either the
device does not have access to the external network (check the WAN indicator - if it is not lit, it means there are
problems with the cable), or in the network settings of the RG-4402-G VLAN was configured incorrectly.
