_________________________________________________________________________________
_________________________________________________________________________________
TAU-72.IP/TAU-36.IP Universal Network Terminal 53
–
Periodic inform enable
—when checked, integrated TR-069 client will periodically poll ACS server at
intervals equal to 'Periodic inform interval' value in seconds. Goal of the polling is to identify possible changes in
the device configuration.
–
Periodic inform interval
—ACS server polling interval.
–
Username
—username used by client to access the ACS server.
–
Password
—password used by client to access the ACS server.
–
ConnectionRequest username
—username used by ACS server to access the TR-069 client. Server sends
ConnectionRequest notifications.
–
ConnectionRequest password
—password used by ACS server to access the TR-069 client. Server sends
ConnectionRequest notifications.
If there is a NAT (network address translation) between the client and ACS server, ACS server may not be
able to establish the connection to client without specific technologies intended to prevent such situations.
These technologies allow the client to identify its so called public address (NAT address or in other words
external address of a gateway, that covers the client.) When public address is identified, the client reports it to
the server that uses this public address for establishing connection to the client in the future.
–
NAT mode
—TR-069 client operation mode in the presence of NAT;
identifies the method, that will be
used by client for obtaining its public address information. Available modes:
–
STUN
—
use STUN protocol for public address identification. When choosing STUN client
operation mode, you should define the following settings:
–
STUN server address
—STUN server IP address or domain name.
–
STUN server port
—STUN server UDP port (3478 by default).
–
Minimum keep alive period, seconds and
Maximum keep alive period, seconds
—define the
time interval in seconds for periodic transmission of messages to STUN server for public
address discovery and modification.
–
Public address (Manual)
—
manual mode, when public address is explicit in configuration; in this
mode, you should add a forwarding rule on a device that acts as a NAT for TCP port used by TR-
069 client. When the manual mode client ('Manual') is selected, the public client address should
be specified manually.
–
NAT address
—IP address of a public NAT.
–
Off
—NAT will no be used—this mode is recommended only when the device is directly
connected to ACS server without network address translation. In this case public address will
match local client address.
To discard all changes made to configuration, click
'Undo All Changes'
button.
To apply changes, click
'Submit Changes'
button.
