ELTEX MES1000, Руководство по эксплуатации

Страница: 101 / 231

MES1000, MES2000 Ethernet Switches 101
ring ring_id
0..15
Create a ring with ring_id identifier and enter the ring
configuration mode.
no ring ring_id Remove a ring with ring_id identifier.
set ring ring_id
{ enable | disable }
0..15 Enable or disable ring operation with ring_id identifier.
Ring configuration mode commands
Command line request in configuration mode appears as follows:
console(config-eaps-domain-ring)#
Table 5.94 —EAPS ring configuration mode commands
Command Value/Default value Action
primary-port
{gigabitethernet gi_port |
fastethernet fa_port | port-
channel group }
gi_port: (1..3/0/1..28);
fa_port: (1..3/0/1..24);
group: (1..8)
Select the primary switch port, included in the ring.
secondary-port
{gigabitethernet
gi_port |
fastethernet fa_port | port-
channel group }
gi_port: (1..3/0/1..28);
fa_port: (1..3/0/1..24);
group: (1..8)
Select the secondary switch port, included in the ring.
role {master | transit}
level
level-id
level-id: 0..1
Select the switch role in the configured domain and ring.
Possible roles:
-
master —device is the master node
- transit —device is the transit node
- edge —adjacent node, that belongs to both primary and
secondary rings
- sub-
edge —auxiliary adjacent node, that belongs to both
primary and secondary rings
role {edge | sub-edge}
-
EXEC mode commands
Command line request in EXEC mode appears as follows:
console#
Table 5.95 —EXEC mode commands
Command Value Action
show eaps [domain
domain_id [ring ring_id ] ]
domain_id: 0..63;
ring_id: 0..15.
Request the information on the state of domains and EAPS
rings.
5.16.8 G.8032v2 (ERPS) protocol configuration
ERPS ( Ethernet Ring Protection Switching ) protocol allows to increase stability and robustness of
data network with ring topology by decreasing the restoration time after the failure. Restoration time
does not exceed 1 second, that is substantially lower than the network reconstruction in case of spanning
tree family protocols.
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.96 —Global configuration mode commands
Command Value/Default value Action
erps
-
Enable ERPS protocol operation.
no erps Disable ERPS protocol operation.
erps vlan vlan_id 1..4094 Create ERPS ring with VLAN R-APS identifier, that will be used