46
Parameter settings
Interface KNX B8-TH
• Version: 24.08.2016 • Technical changes and errors excepted.
Set the output send pattern.
Blocking
If necessary, activate the block for the logic output and set what a 1 or 0 at the block
input means and what happens in the event of a block.
The behaviour of the output on release is dependent on the value of the parameter
"send pattern".
Output value object A if
monitoring period is exceeded
0 … 255 / 100% / 360° / 127; 0
Output value object B if
monitoring period is exceeded
0 … 255 / 100% / 360° / 127; 0
Send pattern
• on change of logic
• on change of logic to 1
• on change of logic to 0
• on change of logic and periodically
• on change of logic to 1 and periodically
• on change of logic to 0 and periodically
• on change of logic+object receipt
• on change of logic+object receipt
and periodically
Send cycle
(if sent periodically)
5 s • 10 s • ... • 2 h
Use block
No • Yes
Analysis of the blocking object
• At value 1: block | At value 0: release
• At value 0: block | At value 1: release
Blocking object value before first call
0 • 1
Output pattern
On block
• Do not send message
• Transmit block value [see above,
Output value if blocking active]
On release
(with 2 seconds release delay)
[Dependent on the "send pattern" setting]
Output sends on change of logic
• Do not send message
• transmit value for current logic status
Output sends on change of logic to 1
• Do not send message
• if logic = 1
send value for 1
Output sends on change of logic to 0
• Do not send message
• if logic = 0
send value for 0
Output sends on change of logic and cycli-
cally
send value for current logic status
Output sends on change of logic to 1 and
periodically
if logic = 1
send value for 1
Output sends on change of logic to 0 and
periodically
if logic = 0
send value for 0
