25
Parameter settings
Interface KNX B8-TH
• Version: 24.08.2016 • Technical changes and errors excepted.
The
status object
reports the current status of the output (0 = OFF, 0 = ON) and may
for example be used for visualisation, or to switch off the heating pump as soon as the
heating is switched off.
Then define the
type of setting
. Heating and/or cooling may be controlled in two
stages.
General set point values
You may enter separate set point values for each mode or use the comfort set point as
a basic value.
If you are using the controls for both heating
and
cooling, you may also select the set-
ting "separately with switching object". Systems used for cooling in the summer and
for heating in the winter can thus be switched from one to the other.
If you are using the basic value, only the deviation from the comfort set point value is
listed for the other modes (e. g., 2°C less for standby mode).
Cycle
(if sent periodically)
5 s • ... • 5 min • … • 2 h
Send status objects
• on change
• on change to 1
• on change to 0
• on change and periodically
• on change to 1 and periodically
• on change to 0 and periodically
Cycle
(if sent periodically)
5 s • ... • 5 min • … • 2 h
Type of control
• Single stage heating
• Dual-stage heating
• Single-stage cooling
• Dual-stage cooling
• Single-stage h single-stage cool-
ing
• Dual-stage h single-stage cooling
• Dual-stage h dual-stage cooling
Setting the nominal values
(if only heating or only cooling is used)
• separately
• with comfort set point as a basis
Setting the nominal values
(only if both heating and cooling are used)
• with separate nominal values with
switching object
• with separate nominal values without
switching object
• with comfort set point as a basis with
switching object
• with comfort set point as a basis without
switching object
