7
Addressing of the device at the bus
Interface KNX B8-TH
• Version: 24.08.2016 • Technical changes and errors excepted.
2.3.2. Diagram
2.4. Instructions for assembly and initial start-up
Never expose the sensor to water (e.g. rain) or dust. This can damage the electronics.
You must not exceed a relative air humidity of 95%. Avoid condensation.
After the bus voltage has been applied, the unit will enter an initialisation phase lasting
a few seconds. During this phase no information can be received via the bus.
3.
Addressing of the device at the bus
The device is supplied with the bus address 15.15.250. You can program another ad-
dress into the ETS by overwriting the 15.15.250 address or by teaching via the pro-
gramming key.
Binary contacts
KNX
Black
Button
Temperature sensor
Ill. 3
LED
T-NTC-ST
Temperature / humidity sensor
T/TH-UP basic
1
2
3
4
5
6
7
8
IN 1
IN 2
IN 3
IN 4
IN 5
IN 6
IN 7
IN 8
white
Black
Yellow
Black
Purple
Black
Blue
Black
Red
Black
Brown
Black
Green
Black
Grey
Black
White
Yellow
Purple
