8
Care and maintenance
Remo KNX RF remote control
• Version: 14.02.2018 • Technical changes and errors excepted.
3.3.5. Scenes
Each scene button is used to control two scenes: The left button half for one, and the right
button half for the other scene.
Tap
a button half for a short time to
call the scene
.
Holding it longer
saves the scene
in the current state (e.g. movement position, dimming
level etc.), provided this function was activated in the ETS.
For ETS settings,
see manual, Chapter
Channel 1...8
, section
Scene
.
4.
Care and maintenance
Please carefully clean the remote control with a damp cloth. Do not use detergent.
4.1.
Troubleshooting
Problem:
The display is off, the remote control does not react:
Problem:
The display is on, the device/drive does not react to button presses:
Cause
Procedure
Transport block active
Please connect the remote control to the power supply using
a charging cable. This deactivates the lock.
Battery not charged
Please connect the remote control to the power supply using
a charging cable to charge the battery. The charge status is
shown with the battery symbol at the top right corner of the
operation pages.
Cause
Procedure
Wireless contact has been lost,
transmitter is too far away from
the receiver
Choose another location
No voltage to receiver unit or
faulty receiver unit
Switch on the receiver unit (e.g. the control unit). Should
wireless contact still not be established, please contact
Customer Service
