7
Using the remote control
Remo KNX RF remote control
• Version: 14.02.2018 • Technical changes and errors excepted.
ETS settings,
see manual, Chapter
Channel 1...8
, sections about
shutters
,
blinds
,
awnings
or
windows
.
3.3.2. Switching devices on/off
Tap1 to switch on
.
Tap0 to switch off
.
If the ‘Feedback’ setting is activated in the ETS, the status reported by the bus (on/yellow
symbol or off/grey symbol) is displayed. Otherwise, there is no feedback for the status.
For ETS settings,
see manual, Chapter
Channel 1...8
, section
Switching
.
3.3.3. Dimming
A shorter tap
on
+ switches on
, tapping on
- switches off
.
A longer tap
on
+ adjusts the light to a brighter setting
, holding
-, to a darker set-
ting.
If you release the key, the brightness stops changing.
The time interval between short and long and other parameters are set in the ETS. If the
‘Feedback’ setting is activated in the ETS, the status reported by the bus (on/yellow symbol
or off/grey symbol) is displayed. Otherwise, there is no feedback for the status.
The dimming percentage is shown in the button, left of the symbol, if the ‘Feedback’ setting
was activated in the ETS.
For ETS settings,
see manual, Chapter
Channel 1...8
, section
Dimming
.
3.3.4. Changing temperature
Adjusting heating or cooling
Tap+ to increase the target temperature
.
Tap- to reduce the target temperature
.
The current target temperature is shown in the button, left of the symbol, if the ‘Feedback’
setting was activated in the ETS (always for temperature objects). The way the temperature
change takes place is set in the ETS.
For ETS settings,
see manual, Chapter
Channel 1...8
,
section
Temperature
.
