15
Channel setting in the ETS
Remote control Remo KNX RF
• Version: 14.02.2018 • Technical changes and errors excepted.
ing the button for a longer time. If this function is activated, set the duration that the button
must be held to recognise the save command.
5.3.1. Control modes for drive control
If channels are used as switches to operate shades or windows, then various control modes
can be set. Standard, Standard inverted and Comfort.
Standard:
Short tap to move the drive step-wise and to stop it. Hold it longer to move the drive to the
end position. The time difference between ‘short’ and ‘long’ can be adjusted.
Standard inverted:
Short tap to move the drive to the end position. Hold it longer to move the drive step-wise
and to stop it. The time difference between ‘short’ and ‘long’, as well as the repeat interval
can be customised.
Comfort mode:
In comfort mode, short tapping, holding the button slightly longer and holding it for a long
time trigger different reactions from the drive. The time intervals are configured individual-
ly.
Short tap
(shorter than Time 1): The drive is positioned step-wise and stopped.
Holding it slightly longer
(longer than Time 1, but shorter than Time 1+2): Drive running.
Drive stops when the button is released.
Long holding
(release after Time 1+2 runs out): Drive moves independently to the end po-
sition. The movement can be interrupted by a short tap.
Scenario function
• Activate
• Activate and save
Press key for longer than (in 01 s)
--> Scene saving
(If ‘and save’ was selected)
1...50; 30
Control mode
Standard
Behaviour when a button is operated:
short = stop/step; extended = up or down
Time between short and long
in 0.1 seconds
1...50; 10
Control mode
Standard inverted
Behaviour when a button is operated:
short = up or down, long = stop/step
Time between short and long
in 0.1 seconds
1...50; 10
Repetition of the step command
on long button actuation
every 0.1 s... • every 2 s; every 0.5 s
