5mm
5mm
English
62
Hydrostat speed control belt tension
• To change this belt, the 3 belts must first be taken off the cutter drive (see above).
• Then loosen both belt catchers by unscrewing the M8 bolt (spanner size 13) so that the
belt holder can be tilted aside
• Replace the belts with belts of a similar type and length.
• The pump should not turn if the lever is in its idling position (not powered). For more
information about adjusting, you are referred to § 11.4.3.4
• After putting the belts back on, the belt catcher needs to be
replaced so as to prevent the belts from coming off when
decoupling. They should be put on such that there is about
5mm remaining between the pulley and belt catcher.
• After calibrating and testing the belt tension, replace the
protective covers.
Belt catchers
M8 bolt
