ELEKTRA Crema Caffe, Инструкция по эксплуатации

Страница: 41 / 68

41
CHANGING THE ACTIVATED CARBON CARTRIDGE (A-K with WTS)
When the following alert appears on the display:
“EXHAUSTED ACTIVE CARBON CARTRIDGE - MACHINE ON - REPLACE IMMEDIATELY
AND THEN RESET THIS ALERT USING THE PROGRAMMING KEY”
contact Technical Assistance .
WARNING: WATER TREATMENT SYSTEM FAULT (A-K with WTS)
If the following alert appears on the display:
“WATER TREATMENT SYSTEM FAULT - MACHINE ON - REPAIR”,
this is a fault that does not negatively affect the use of the machine.
To dispel all doubts regarding the actual presence of a fault as opposed to the existence
of other anomalous situations not connected to the machine, it is advisable to run
the following procedure:
1) Switch the machine off and then on again: the following alert will appear on the display:
“WATER TREATMENT CIRCUIT RINSE UNDER WAY - DURATION 60 MINUTES - MACHINE ON”
wait, while continuing to operate the machine.
2) Once the rinsing cycle has been completed, the following alert will appear
on the display:
“LOAD SALT AND PRESS ENTER - MACHINE ON”:
follow these instructions because the machine wants to regenerate the resins in order
to repeat the various controls.
If the fault alert reappears, contact Technical Assistance.
The aim of this automatic procedure is also to protect the machine from using salty
regeneration water due to a fault.
If the machine is switched off (e.g. for repairs) while this alarm is still in course, when it is
then switched on again, before using the water from the softening circuit, it automatically
runs a complete rinsing cycle on the circuit, after which it carries out another regeneration,
continuously monitoring the suitability both of the fresh water and of the salt solution used
for washing the resins.
17
18