Electrostatic Technology, Inc
FlexiCoat
®
Model 300 Coater
Serial #20158
15
7 INSTALLATION
These instructions for installing, operating and maintaining the FlexiCoat
®
Model 300 Coater
must be followed for its safe and efficient operation. In particular, precautions should be
observed whenever the unit is operated. Study this manual before installing or operating
equipment. Some voltages employed in this equipment are high. Remember that any source of
voltage can be hazardous.
7.1 LOCATION
1. Place
"FlexiCoat
®
" and ancillary equipment on a level surface at the desired
location. Refer to Floor Plan Drawing in the Appendix of this manual.
2.
Look over the entire Collector Module and refer to the Customer Product
Manual #303 867B (located in the Appendix) for installation information not
specified in this manual. Although your machine may be shipped pre-
assembled, please read through this manual before installing.
7.2 AIR
CONNECTIONS
E.T.I. supplies the Poly-Flo tubing for all air connections. Refer to the Pneumatic
Schematic in the Appendix of this manual.
1.
Check that all pneumatic hoses are connected securely throughout the
machine.
2.
Connect the 1/2 inch air supply hose to the main air inlet located on the right
front Powder Collector leg.
NOTE:
If Dry inert gas is used, consult the E.T.I. factory.
7.3
ELECTRICAL
CONNECTION
1.
Connect the Booth and Electrical Panel to a true earth ground.
2.
Connect the FlexiCoat
®
Model 300 Coater electrical cord to a receptacle
rated: 220 Volts, 50 Hertz, 1-Phase, 20 Amp.
CAUTION:
ALL RECEPTACLES MUST HAVE A PROPER
GROUND CONNECTION.
