Electrolux Side by Side Refrigerators, Руководство по обслуживанию

Страница: 71 / 100

70
Figure 20
Gear driver
used to
connect door
closer to arm
on door.
To replace door closer, remove three screws then lift
closer from housing. The door is held in place by a shaft
at the top. The spring that holds the door closed and
seals it against the housing is over the shaft. The shaft
can be removed by using a small punch. (See Figure
21.)
Figure 21
Use a small punch to remove shaft.
Both the water and ice actuators are tensioned by a
stainless steel, two bladed spring which is mounted
behind the actuator switches. The spring is held in place
by two screws. (See Figure 22.)
Figure 22
Tension Spring
For Actuators
The actuators are held in place by stainless steel clamps
at each end of the actuator and the two bladed spring in
the middle. (See Figure 23.) The actuators can be
detached by removing four screws and lifting the paddle/
ice chute out of the housing.
Figure 23
Spring and clamps used to
hold actuators in place.
On models that dispense only water and ice cubes, the
dispenser comes apart the same way as on models
with a control board. The difference is, there is no light
in the housing and the wiring to the actuator switches is
connected directly to the plug in the door wiring harness.
(See Figure 24.)
Connector from
door harness to
actuator switches
Figure 24
The original heater for the ice chute and housing is
foamed in place with the one-piece door. It is connected
to the door wiring harness by a plug coming out of the
inner door panel. The plug has two black wires
connected to it. (See Figure 25.)
If the heater fails, install an external heater on the
housing chute opening in place of the internal heater.
The replacement heater will connect to the same plug
as the original heater. (See Figure 26.)
Plug for chute heater
Check across two black wires
to test internal chute heater.
Figure 25