Electrolux Side by Side Refrigerators, Руководство по обслуживанию

Страница: 10 / 100

9
Roller
Assembly
Roller
Mounting
Bolts
Roller
Adjusting
Bolt
Roller
Mounting
Screw
SECTION B - REFRIGERATOR CABINET
Adjustable Door Bins
Some models have adjustable door bins that can be
moved to suit individual needs.
To move door bins:
1. Lift bin straight up.
2. Remove bin.
3. Place bin in desired position.
4. Lower bin onto supports until locked in place.
CABINET DOORS AND GASKETS
The exterior door panels are made from one piece of
heavy gauge, deep drawn, cold-rolled steel. A wide
flange at the periphery is formed integral with the exterior
door panel.
Next generation model doors are filled with rigid Urethane
foam insulation prior to assembly of the inner panel and
door gasket.
The door inner panels are vacuum formed from high
strength plastic.
BASIC CONSTRUCTION
Next generation models have clean back cabinets and/or
forced air condensers. The condenser is located under
the cabinet bottom. The cabinet wrapper consists of a
one-piece top and sides formed of prepainted steel, with
an interlocking, snap-in, galvanized steel back panel. A
separate steel frame is attached to the cabinet bottom.
The compressor compartment houses the compressor,
condenser, and fan motor.
All cabinet seams have special sealing materials applied
as vapor barriers, prior to installation of the inner liner
and foam insulation.
COMPRESSOR MOUNTING
All next generation models side by sides will have a
dynamic condenser and a unitary drain pan assembly
that is mounted to the bottom of the refrigerator cabinet
just behind the toe grille. (See Figure B1.)
The compressor is
mounted on rubber
grommets with metal
inserts, then bolted to
the base using four Hex
head,
14-28
shoulder
screws. (See Figure B2)
INSULATION AND
INNER LINER
The cabinet wrapper and
compartment liner are
bonded together with a
core of "Urethane" foam
insulation to form a slim
three-ply wall of single-
unit construction.
Shoulder Screws
Washers
Inserts
Rubber
Grommets
Figure B2
The one piece freezer and the one piece food inner liners
are vacuum formed of tough corrosion-proof ABS/HIPS
plastic material. The liners are not removable.
FRONT AND REAR ROLLERS
The front roller is mounted with two screws to the cabinet
base and one screw to the front of the cabinet. (See
Figure B4) The adjustment screw at the top of the roller
is turned clockwise to raise the cabinet, and counter-
clockwise to lower the cabinet (See Figure B5). While
making adjustments, slightly raise the cabinet to reduce
the strain on the roller assembly.
Figure B4
Figure B3
Figure B1
Drain Pan