Electrolux Side by Side Refrigerators, Руководство по обслуживанию

Страница: 7 / 100

6
UNCRATING
Uncrating instructions are clearly printed on the shipping
carton. Under no circumstances should a refrigerator be
uncrated until these instructions have been read.
Additional handling and installation information is
provided in the "Installation Tips" affixed to the
refrigerator door and in the Owner's Guide, located in one
of the drawers inside the refrigerator. Pay particular
attention to the information regarding hand trucking,
leveling and door alignment.
MODEL AND SERIAL NUMBER
Model and Serial Numbers are found on the Serial Plate
located on the ceiling of the refrigerator compartment,
just behind the compartment light, or on the right side at
the top (See Figure A1).
AIR CIRCULATION
Proper air circulation must be maintained for efficient
refrigerator operation. Refer to the Owner's Guide for
recommended clearances. Install the refrigerator out of
direct sunlight and away from the range, dishwasher, or
other heat sources.
CAUTION: Do not install the refrigerator where
the temperature will drop below 55°F (13°C), or
rise above 110°F (43°C) because the compressor
will not be able to maintain proper temperatures.
Allow an extra
3/8
" on the top and sides, and 1" from the
back for ease of installation, proper air circulation, and
plumbing and electrical connections. If the hinge side of
the unit is placed against a wall, allow a ½" minimum
between hinges and wall to permit proper door swing.
NOTE: Do not block the toe grille on the lower front
of the refrigerator. Sufficient air circulation is
essential for proper operation of the refrigerator.
ELECTRICAL INFORMATION
The refrigerator must be plugged into a dedicated AC
only electrical outlet. The circuit should be protected by
a circuit breaker or time delay type fuse of the capacity
noted on the serial plate.
NOTE: If voltage varies by ±10% of supply voltage,
performance of the refrigerator may be affected.
Operating the refrigerator with insufficient power
can damage the compressor.
The refrigerator power cord is equipped with a three prong
grounding plug. It must be plugged directly into a properly
grounded three prong receptacle. The receptacle must be
installed in accordance with local codes and ordinances.
Do not use an extension cord or an adapter plug.
SECTION A
INSTALLATION INSTRUCTIONS
LEVELING
The refrigerator must be leveled with all bottom corners
resting firmly on a solid floor. Adjust the front rollers to
level the cabinet from side-to-side and front-to-rear. Keep
the cabinet as low as possible for stability. Never adjust
the cabinet rollers so the front is lower than the rear.
To adjust the front rollers:
1. Open refrigerator and freezer doors.
2. Remove toe grille by pulling it straight out. (See Figure
A2.)
3. Adjust rollers by turning each roller adjusting bolt with
flat-blade screwdriver, adjustable wrench, 3/8" socket
wrench, or 3/8" nutdriver until refrigerator is level and
stable. (See Figure A3.)
Raise
Figure A3
Figure A2
Figure A1
NOTE : Rear rollers are not adjustable.