TSE-P 04.00 EB
7/50
599 34 22-16
4,5,6“OPTIONS” buttons
The number and type of OPTIONS buttons vary according to the
model. All OPTIONS buttons are effective during the programme
selection phase, but only after the type of fabric has been selected.
After the “START/PAUSE” button has been pressed, the options can
generally be selected up until the start of the phase whose parameters
are to be modified.
“RINSE HOLD” button
The RINSE HOLD button is effective during the entire duration of the programme.
This function can be selected in COTTON, SYNTHETICS, DELICATE FABRICS and WOOL cycles; in
certain models, it is combined with the SPIN button.
When this option is selected, the appliance will not drain the tub at the end of the final rinse (in order to
prevent creasing the fabrics). At the end of the cycle, the LED corresponding to the START/PAUSE button
(and, where applicable, the phase indicator LED) will begin to flash to indicate to the user that the water in
the tub must be drained.
The following options can be selected to complete the programme:
Þ
drain and spin:
Press START/PAUSE. The appliance will drain the tub and then perform a spin cycle at
the maximum speed for the programme previously selected.
Þ
select a spin speed
using the SPIN button and then press START/PAUSE.
Þ
drain only:
Press SKIP/RESET
once
, until the DRAIN pilot lamp lights, then press START/PAUSE.
If the RINSE HOLD option is selected in a COTTON cycle, the water fill for the final rinse will take place at a
higher level.
“PRE-WASH” button
This option adds a pre-wash phase at the beginning of the cycle. The PRE-WASH option can be selected
only during the programme selection phase, and is not available in WOOL cycles.
The PRE-WASH option cannot be selected together with the STAINS or SOAK options.
“SOAK” button
This option can be selected in COTTON, SYNTHETICS and DELICATE FABRICS cycles (but only in the
programme selection phase), and adds a pre-wash at the beginning of the cycle.
30 minutes after the start of the cycle, the water is drained and the appliance passes to the subsequent
phase.
The DELAYED START button (if featured) can be used to select a SOAK time from 1 hour to 24 hours. The
delay time will be shown in hours in the display window during the selection phase; after the cycle has been
started, the delayed-start countdown will be shown in hours until it falls below 10 hours, after which the time
will be shown in hours and minutes. At the end of the SOAK phase, the water is drained from the tub and the
washing programme starts.
The SOAK option cannot be selected together with the STAINS and PRE-WASH options.
“STAINS” button
The STAINS option can be selected in COTTON, SYNTHETICS and DELICATE FABRICS cycles with
temperatures of 40
°
C or higher, and can also be selected during the washing phase.
This option adds the STAINS phase, in which special additives are introduced into the tub from the pre-wash
compartment after the BIO phase with heating to 40
°
C, and an additional 10 minutes of motor movement.
The STAINS option cannot be selected together with the PRE-WASH/SOAK, INTENSIVE and QUICK
/DAILY options.
