54
of the parts to be cleaned and how often they should be
cleaned.
G.3
Cooking chamber
It is suggested to clean it at least once a day in case of daily
use: it could happen, with particular types of cooking, to have
to clean it even more than once a day.
To clean the cooking chamber, use the dedicated programs as
explained in F.15
paragraph.
G.4
Boiler or steam generator (models
equipped only)
It is suggested to descale it every day in case of daily use.
The descaling cycle is included in the same washing programs
as the cooking chamber, with the exception of the rinsing
program. Make sure to add the specific tab as explained in
F.15
paragraph.
Using the ecological “Green Spirit/Economizer“ feature
excludes the descaling of the steam generator, which over
time leads to the accumulation of limescale. When the oven
shows the message “dESC“, descale as indicated in the
instructions in F.15.1
section of the above
paragraph.
G.5
Cooking chamber filter
This filter is clearly visible in the centre of the bottom of the
cooking chamber and is used to prevent damage to the
washing pump and/or to avoid obstructions in the washing
circuit.
Once a week
:
1. Undo the screw from the centre of the filter;
2. Remove the filter from its housing;
3. Wash the filter in the dishwasher with a gentle programme;
in other cases, wash the filter by hand with neutral dish
washing detergent and rinse thoroughly;
4. Refit the filter in its place and screw the central screw to fix
it.
G.6
Air filter
It is a polyurethane sponge, housed in a support equipped
with slits for the inlet of the cooling air of the oven components
(see figure for “table-top“ models for example).
It avoids that the impurities of the kitchen environment (oils,
greases, flours, powders,...) are transported on the internal
components causing malfunctions.
Once a month
:
1. Unlock the filter support by unscrewing the screws and
remove it;
Example of 6-10 GN model
2. Remove the filter and degrease it by washing it with dish
detergent;
3. Dry the filter and put it back in the support;
4. Put the support back in place. If necessary, depending on
your model, secure it with the screws.
IMPORTANT
For safety reasons, the oven is equipped with a
mechanism to detect the presence of the filter
support. If the filter is not refitted, a message is
given indicating that the filter should be put back in
place. After 8 hours of operation without a filter, the
oven will freeze until the support is refitted.
G.7
Door gasket
The silicone gasket that surrounds the cooking cabinet facade
is an essential element in achieving the desired cooking
results and preventing air, water or steam leakage during
oven operation. The gasket is the most stressed element of the
oven because it is subject to multiple types of stress: thermal,
chemical, physical.
At least
once a day
(preferably after the washing cycle of the
cooking chamber) carefully clean the facade and the gasket
using a cloth soaked in water.
IMPORTANT
It is necessary to clean the gasket repeatedly
during daily use, especially when cooking temper-
atures above 220
℃
are used. Cleaning the gasket
with a damp cloth during grilled cooking consid-
erably increases the life of the gasket. Never use
abrasive products to clean the gasket. Do not leave
the oven cooking at high temperatures without a
load.
Replace the facade gasket every six (6) months.
To replace it, proceed as follows:
1. Remove the gasket from its seat;
2. Clean the latter of any traces of dirt;
01:20 h:m
0 120
:
:00
160°C
50%
20
%
25
°C
?
Manual
Automatic
Prog rams
Custom
Cleaning
Settings
Help
User
Agenda
Training
1
2
CLACK!
