Electrohome VistaGRAPHX 10K, Руководство пользователя

Страница: 35 / 127

Downloaded from Projector.com
23(5$7,21
9LVWD
*5$3+;
#;3343 . HU * V # 0DQXDO
60:
•
the rear of the projector is inaccessible
•
the lighting conditions are unsuitable for proper IR transmission
•
you want to use a separate keypad for each projector in a group
Keep in mind the following guidelines:
4,
Press keys one-at-a-time; there are no simultaneous key presses required.
5,
For any key having an “*” ( 3RZHU - , for example), hold the key for a second or
two in order to toggle the function with a single key press. For other keys (or
to use a “*” key in conjunction with
21
or
2)) ), a momentary press
similar to a mouse click is sufficient.
6,
Press the “lightbulb key” for approximately one second to temporarily
illuminate the backlight for the keys without sending any other command.
7,
, , 21
, and
2))
repeat their “arrow” actions when held down. For
other keys, release and press again to repeat an action.
8,
If you press a key while the projector is busy with another action, such as
during a power-up, the key press may not take effect.
When you turn on the projector it begins operating at presentation level, such as
an image from the most recently used source signal. The projector temporarily
leaves presentation level whenever you use the keypad to work with control
settings, display menus, or on-line help. For example, pressing
0HQX
after startup
displays the main menu — presentation level is no longer active, although the
image continues to be displayed in the background. Press
0HQX
again (or
([LW
) to
return to presentation level.
Specific keypad commands are explained below:
3RZHU # 21 2 2))
Press and hold for a second or two to turn the projector on or off with a single
key press. Or press
3RZHU -
followed immediately by
21 or 2))
if you want to
guarantee the correct toggle (useful if you are unsure of the present status).
NOTES: 1) Whenever the projector is turned off, the lamp cooling fans remain
on for about five minutes to cool the lamp sufficiently. Do not unplug the
projector unless the lamp cooling fans have shut off. 2) It is a good idea to
avoid turning a projector back on until it has been off for at least five minutes.
Hot re-strikes of the lamp may reduce lamp life.
,QSXW #4
Press ,QSXW 4
to select the input connected to
,1387 #4#
on the projector (data input).
This is the same as entering
,QSXW
.
,QSXW #5
Press ,QSXW 5 to select the input connected to
,1387 #5#
on the projector (an optional
interface). This is the same as entering ,QSXW
.
,QSXW #6
Press ,QSXW 6 to select the input connected to
,1387 #6#
on the projector (composite
video). This is the same as entering ,QSXW .
*XLGH # WR # .H\SDGV
ö
.H\SDG # &RPPDQGV
ö
3RZHU -
#
,QSXW 4
##
,QSXW 5
#
,QSXW 6