Electro-Voice X1-212/90, Руководство по установке

Страница: 29 / 64

Figure 6.8: X1/X2 spreader bars properly orientated for use with pull-up grid for X2 array.
Figure 6.9: X12PU-BGK installed
Using the X12PU-BGK with an X12TE-GRID for compressing an X1 or X2 array
The X12PU-BGK pull-up bar is installed on the bottom-most element in the array.
!
Caution!
Verify each end of the spreader bar is pinned in the same number hole on both sidearms.
Ensure the pins attaching the grid sidearms are fully locked into the holes in the ends of the
spreader bar.
To install the X12PU-BGK, do the following:
1.
Extend and lock the front link bars.
2. Extend and lock the rear link bars.
3. With the sidearm V-blocks facing up and the solid bar facing the rear, guide the V-blocks
on the extended link bars (A).
Do not release the sidearm until it is securely attached to the loudspeaker.
4. Insert the attached quick-release pins (B) through each sidearm and link bars, front and
rear.
Ensure all quick-release pins are completely through the sidearms and securely locked.
en 29
Electro-Voice Installation Manual 2015.04 | 02 | F.01U.310.953