EASYTRACK MANAGER
EasyTrac k
Vers ion: 2004/06/17
Page 28
SMS interval
Please specify the period of time for which
EasyTrack shall wait between two messages.
The maximum value is 1440 minutes, which is
equal to 24
hours.
SMS retry
Please enter the number of retries
(1 up to 10)
which EasyTrack shall carry out in the event of a
GSM communication error - for instance if
EasyTrack temporarily cannot find any GSM net.
The default value of EasyTrack is 5 retries.
Sending of first SMS
after 30 seconds
( Checkbox )
Select the checkbox for sending an SMS after 30
seconds after power-up of EasyTrack.
Sending of first SMS
with valid GPS data
(Checkbox )
Select the checkbox for sending an SMS after
power-up, if EasyTrack has a valid GPS position.
•
Measurement Settings
If EasyTrack is supposed to transmit also the vehicle-
related data within a SMS, the scaling parameters for
Engine Speed
and/or
Road Speed
must be specified.
Since the number of impulses per kilometer varies with
different vehicles, it is necessary to adjust EasyTrack
for the appropriate vehicle.
Note:
In all fields only decimal numbers are allowed.
Engine Speed
Scale
(Rev./Min.)
In the input field, enter the 100% value, which is to be
used by EasyTrack as a maximum value when
partitioning into 3 ranges (Range 1 up to Range 3) see
chapter 4.7.5 Range 1, 2 and 3.
This input field has a maximum value of 65535
revolution per minutes.
Engine Speed
Pulses
(Pul./Rev.)
The numerical characteristic giving the value of the
input signal required to show and record the revolutions
of the engine. This constant shall be expressed in
pulses per revolution. This input field has a maximum
value of 255 pulses per revolution.
Road Speed
Scale
(km/h)
see: Engine Speed
Scale
This input field has a maximum value of 65535
kilometers per hours.
Note:
1 km/h <=> 0.621 mph
Road Speed
Pulses
(Pul./Meter)
The numerical characteristic giving the value of the
input signal required to show and record a distance
traveled of one meter. This constant shall be expressed
in pulses per meter. This input field has a maximum
value of 255 pulses per meter.
Note:
Since Firmware Release 2.0: If you enter the value 0 (zero)
here, the EasyTrack will use the GPS speed instead of wheel
pulses
