EASYTRACK MANAGER
EasyTrac k
Vers ion: 2004/06/17
Page 26
4.7.4 Register Card “Configuration”
figure 11; Register Card
Configuration
Note:
This register card will only show data, if you have a
enabled connection to your EasyTrack.
Via the register card
Configuration
, the configuration
data of EasyTrack are entered. In order to realize a
minimum configuration of EasyTrack, the fields have to
be specified within the group General Data. However, this
way EasyTrack can only perform the transmission of the
position but not of the vehicle-related data such as road
speed, driving time, engine speed, idle time and distance.
To carry out a configuration of EasyTrack, a direct connection
between PC and EasyTrack via a serial cable must exist
(please refer to chapter “Status Bar”).
•
Status Bar
In the lower right corner of the application, the
EasyTrack Manager communication status to EasyTrack is
displayed. If
EasyTrack COM not open
is displayed, no
upload or download of data is possible. In addition, no
actual data can be read from EasyTrack. Refer to
PC Port
on register card
Settings
, to open the appropriate COM
port. If COM port is open and EasyTrack is connected with
the EasyTrack Manager,
EasyTrack available
is shown in
the status bar. If the EasyTrack Manager cannot
communicate with EasyTrack,
EasyTrack not available
is
displayed.
On the left hand side of the status bar, communication
errors between EasyTrack and EasyTrack Manager and
other sources of information are displayed.
