ELCOM Uniq 150, Руководство по обслуживанию

Страница: 15 / 41

22
Elcom, spoločnosť s ručením obmedzeným, Prešov Elcom, spoločnosť s ručením obmedzeným, Prešov
23
Uniq 150 Service manual Service manual Uniq 150
D525: Disconnect connector J1 from mainboard.
2. Release two distance screws and little pull connectors module out.
3. Disconnect other cables from connectors PCB (XC1, XC2, XC3; for Uniq Display only XC3).
4. Now it is possible to pull connector module out thoroughly. Note power supply cable, which is still inside.
Figure 2.8. – Connectors module removal
Distance screw M3 × 10 mm BN3321
Uniq PC connectors – Nx execution
2.8.1. Connectors PCB removal
1. Release four screws to put out connectors PCB.
Figure 2.8.1. – Connectors PCB removal
Connectors holder
Connectors PCB
Screw M2 × 5 mm DIN7985A
Nut M2 DIN934
2.9. Hinge replace
1. It is necessary to release all Uniq 150 hinge in some cases. It is possible to put out all hinge after open-
ing Uniq 150, leg and connectors removal, just release four Allen screws.
2. Pull out hinge cuff.
3. In case of problems with the tilting stiffness tighten the nuts of the hinge.
4. Usually it is possible to regulate tilt in range of 15° in case of standard execution with leg. It is possible
to change direction or enlarge this range by change position of screws described on following figures.
Note: Cuff is designed to bending inrange of 30°. Enlarge the bending can cause excesive cuff deformation
even demage!
Note: Set of cuff must be executed precisely according to figure! Otherwise we cannot guarantee IP54.
Figure 2.9.1. – Hinge replace
Figure 2.9.2. – Hinge section view
Rear cover
Cuff
Leg hinge
Reinforced hinge
Screw M4 × 6 mm DIN7985A
Screw M4 × 6 mm
DIN7985A
Pad M4 DIN125
Pad ø 7 × 11 × 2 mm BN739
Screw M4 × 6 mm DIN912
2.9.1. Hinge setting