elco Aquatop TC Series, Руководство по эксплуатации, Страница: 27 / 48

27
Initial Startup
Parameterization
Initial startup (sometimes referred to as "commissioning") involves the following tasks:
•
The correct assembly, setup, and electrical installation are prerequisites.
•
Make all system-specific adjustments. The "configuration" control side is particularly important. Select the
corresponding control level as follows:
•
On the room controller, use OK to switch to programming.
•
Keep the info depressed for at least 3 seconds and use the rotary knob to select the "initial startup" control level.
Then press OK. Perform function check. Reset the damped exterior temperature.
(Control side "Diagnose consumer," control line damped exterior temperature 8703)
•
Basic display "room temperature"
•
Press 1 x OK
•
Press INFO > 5 seconds
•
Use +/- rotary knob to select "initial startup or technician" level, for example
•
Press 1 x OK
•
Use +/- rotary knob to select "parameter 1612 reduced setpoint," for example from potable water menu
•
Press 1 x OK
•
Use +/- rotary knob to change current value
•
Press 1 x OK -> value is saved
•
Press 2 x ESC to return to basic display
Overview of Initial Startup Parameters
Parameter lines E (end user) and I (initial startup) are displayed in the initial startup level.
The complete parameter list (with lines E, I and F) is displayed in the technician level.
Time and date 1 E Hours/Minutes hh:mm 00:00 23:59 -
2 E
Day/Month
dd.mm 1.01 31.12 -
3 E
Year
yyyy 2004 2099 -
4 F Summer time start dd.mm 1.01 31.12 25.03
5 F Summer time end dd.mm 1.01 31.12 25.10
Control unit 20 E Language -
Deutsch, English, Francais, Italiano, Nederlands Deutsch
40 I
Unit address
-
Room controller 1, room controller 2, HMI,
service unit
Room controller 1
42 I Room contr. 1 assignment - Heating circuit 1, heating circuit 1 and 2 Heating circuit 1
44 I Operation HC2 - Together with HC1, independent Together with HC1
46 I
Operation HCP
-
Together with HC1, independent Together with HC1
48 I
Presence key active duration
-
None, heating circuit 1, heating circuit 2, together Heating circuit 1
500 E Preset value -
Mon - Sun, Mo - Fri, Sat - Sun, Mon, Tue, Wed,
Thu, Fri, Sat, Sun
Mon - Sun
501 E 1. phase ON hh:mm 00:00 24:00 06:00
502 E 1. phase OFF 22:00
503 E 2. phase ON - - . - -
504 E 2. phase OFF - - . - -
505 E 3. phase ON - - . - -
506 E 3. phase OFF - - . - -
516 E
Default values
-
Yes No No
Timer program
heating
circuit 1
C
o
n
tro
l li
n
e
C
o
n
tro
l lev
e
l
Fun
c
ti
o
n
Un
it
Mi
n
Ma
x
Fac
to
ry
settings
F = Function E = End User I = Initial Startup