User Guide
Product: Evolis
Document REF: MIU-5100-C_Evolis Solution GB elancity
Page
6
/
42
Date: 02/09/2020
Confidential document, property of ELANCITY. All copies and transfers are unauthorized without prior consent.
3
TEST YOUR DEVICE BEFORE INSTALLATION
We strongly recommend that you conduct an initial start-up & manipulation of your Evolis
device
BEFORE
installing it at the final desired location. In the unlikely event of a malfunction,
a telephone diagnosis (and also, in the worst case scenario, a factory return) is far simpler if
the unit is not already installed onto its post ‘in-situ’.
The very first step is to connect the battery.
3.1
A
UTO
-
TEST
Once you have connected the battery, turn and set the dial switch to
any position OTHER than ‘off’ (standby).
The Evolis will run a quick
auto-test
(this is perfectly normal and there
is no need to intervene but it IS advisable to observe the display):
1
Speed display
‘188’
should be displayed in green and is
quite simply the device testing all the LEDs
in the display.
2
Speed display
Then,
Three further numbers
will then be
displayed. These equate to the battery
voltage. (e.g. : ‘
147’
= 14.7 Volts). A
normal reading will be situated between
11.7 and 13.4
Text display
‘Init…’
will then be displayed in the lower
part of the device
3
Speed display
‘8’
in red : signifies Bluetooth
‘1’
in green : signifies a GPRS connection
