Application manual
KNX standard wall presence detector with movement function EK-SN2-TP-
…
Rev. 1.0
– 29/09/2022
MAEKSN2TP_EN
© Ekinex S.p.A.
– All rights reserved
Pag. 19
Parameter name
Conditions
Values [Default]
HVAC control output C3
Device type = Master
Disable
Enable
Enable the control channel and show the respective group of parameters.
HVAC control output C4
Device type = Master
Disable
Enable
Enable the control channel and show the respective group of parameters.
Alarm function
Device type = Master
Disable
Enable
Enable the alarm function and show the respective group of parameters.
14.2 Menu: Motion sensors
Figure 17 - Motion sensors parameters window
Parameter name
Conditions
Values [Default]
External switch
as ON / OFF / Dim input
Device type = Master
No
Yes
If enabled, each channel can also be controlled from the KNX bus through communication objects #5-6-
7-8.
For Light control channels, the CO (which is of 1-bit Switch type) also controls the dimming function.
The Manual ON/OFF and DIM function is operated by the switch built-in/connected with KNX interface
module on KNX bus system.
Lux / Time /
Sensitivity(Meter)/
STBY selected by
Device type = Master
ETS
IR
It is used to set the parameter of Lux, Time, Sensitivity (Meter), STBY of detector is changed by ETS
®
software or IR remote control (not available in this product version). When the control mode is set to
“ETS”, all the parameters on detector can only be changed by ETS
®
after completing the object build up.
Note: this setting is only relevant for the two Light Control channels (C1-C2).
