INCLUDES
Main Unit x 1
Rechargeable Base x 1
USB Rechargeable Cable x 1
Remote Unit x
2
Adaptor Input: AC 100V~240V, Output: DC 5V, 0.5A x1 (Optional)
HOW TO TURN ON THE ALARM?
1.
Slide the switch on the back of Main Unit to “ON”
2.
You will hear one long Beep and the LCD display will flash once
to indicate the Main Unit is on.
HOW TO SET THE ALARM VOLUME?
1.
There are four different alarm volumes available L1 (Default), L2 (Low) & L3 (Medium) & L4
(Loud)
2.
After the power is on, continuously press the Main unit button for 2 seconds.
3.
You will hear 2 short beeps and the LCD will display “L1” (default volume)
4.
Select the volume L1, L2, L3 or L4 by pressing the button.
5.
You can hear the sound volume corresponding to the LCD display. L1, L2, L3 & L4 will
display sequentially
6.
If the button is not pressed again, after 2 seconds, the Main unit will memorize the last
volume as the set volume
Remark: You can RESET the volume to L1 (default volume) by continuously pressing the Main unit
button at any time
HOW TO CHARGE MAIN UNIT?
1.
Connect the USB cable to the Charging Base and plug in the USB power source.
2.
Connect the Main unit to the Charging Base to begin charging. (The unit can be charged in
either the ON or OFF position)
3.
While charging, the Main unit LED will turn RED. Once the charging is completed the LED
will turn BLUE
HOW TO PAIR THE MAIN UNIT AND THE REMOTE UNIT?
1.
Connect the USB cable to the USB power source and the
Charging Base.
2.
Slide the Main unit to “ON” then put it in the Charging Base.
3.
Press and hold the Charging Base Pairing Button for more
than 1 second.
4.
You will hear a long “BEEP” sound and the Main unit LCD
display will show numbers “01” (default number) and the
RED/BLUE LED will flash for 30 seconds.
OFF
ON
Reset
DOWN Button
PAIRING Button
UP Button
ELDERLY Safety Alert
