9
Chapter 1 Introduction
13. USB upstream port
Connect a USB cable to this port to:
• Use the touch panel,
• control the monitor via USB, or
• use USB hub function.
14. VGA (D-Sub) connector
Inputs analog signal of a PC.
15. DVI-2 / RGB-2 (DVI-I)
connector
Inputs DVI signal (digital, analog) of a PC.
16. DVI-1 (DVI-D) connector
Inputs DVI signal (digital) of a PC.
17. RS232C port
D-Sub 9-pin (female) connector:
Use this connector to control the monitor via RS-232C communication.
18. Banding band holder
Holds a banding band used to secure the cable.
19. Ethernet port
Connect a network cable to this port to control a monitor via Ethernet.
a b
a) Link LED
Green
Network connection is
established.
When
turned off
Network connection is not
established.
b) Status LED
Blinking
orange
Data communication in
process.
20. RS485 port
Use this connector to control the monitor via RS-485 communication.
21. OSD port
Use this port to control the control buttons from outside.
22. DC power connector
Installs the DC power terminal block.
23. DC power fuse
A DC power fuse is installed.
24. Functional earth terminal
The tapped hole is M4 (4 mm nominal diameter), 6 mm depth.
25. AC power connector
Connects the power cord.
The insulation cover is attached to the AC power connector at factory
shipment.
26. AC main power switch
Turns the AC main power on or off.
| : On,
○
: Off