Eilon Engineering RON 2000, Инструкция по эксплуатации

Страница: 23 / 37

_NV Ron 2000 4.2 20/37 3/25/2016
9.5 Print, Mode Selection (only if the system is
equipped with the RS-232 output)
Enter into the options menu by following the instructions in section 9. Use
the arrow keys ↑↓ to select
PRINT
from the options menu and press
ENTER
.
Use the arrow keys again and select the desired output mode:
D. MAND
(on demand)
CONT.
(continuous stream)
Press
ENTER
. The display will show OK and revert back to the options
menu. Press ESC again to exit the options menu.
On demand mode:
To output data to a PC/printer when the RS-232 is set to on demand mode,
simply press PRINT while a load measurement is displayed.
Continuous mode:
There are two continuous modes. Each system is factory set to one or the
other.
1. Continuous - unconditional constant flow(default): the displayed valued
will be output at a rate of about once per second.
2. Continuous - upon value change: the displayed value will only be output
when there is a change in the reading. If there is a steady change in value, a
reading will be output at a rate of about once per second. If there is no
change to the load value, no data will be output.
Available print commands:
Execute the following commands by pressing the corresponding key when a
load value is displayed.
PRINT – prints the current displayed value (used only in on demand mode).
MAX – besides displaying the current stored maximum load value, will
output this value as well (see the MAX section).
TOTAL then PRINT (if included) – prints the sum total of all load values
stored in the totalizer memory and the number of loads that are currently
saved.
DATA L. then PRINT (if included) – prints all the load values currently stored
in the data logger memory (see Data Logger section below).