Eiki MCD-100, Руководство пользователя

Страница: 66 / 96

66
10. PJ Controller
2. Check Option items
Check the conditions where you would choose the MCI to send alert messages.
※ Regarding the alert message, see below samples.
3. Input the message to attach the E-mail.
The message typed here will be attache to the alert message.
Samples of Alert Message
* When the internal temperature is too high
TITLE: Message from projector
Projector Model Name: XX100
TCP/IP: 192.168.0.111
Projector Name:
It sends you following message.
*The Projector lamp is turned off, because internal projector temperature is too high..
Wait for Temperature Warning Indicator turned off, and then turn the Projector on again.
If the Indicator continues flashing, check the air filter for dust accumulation.
[A] 21.5degrees centigrade[B] -13.7degrees centigrade[C] 51.6degrees centigrade
Temperature of Sensor B is too high.
Temperature of Sensor C is too high.
* When the internal power circuit is failed
TITLE: Message from projector
Projector Model Name: XX100
TCP/IP: 192.168.0.111
Projector Name:
It sends you following message.
*The Projector lamp is turned off, because projector power circuit is failed..
Unplug this projector from AC outlet and ask servicing to qualified service personnel.
* When the life span of the lamp has been expired
TITLE: Message from projector
Projector Model Name: XX100
TCP/IP: 192.168.0.111
Projector Name:
It sends you following message.
*The life-span of lamp is reached.
Lamp replacement is required.
* The Network Unit let users know the information which thermal sensor [A], [B] or [C] inside the
projector detected the abnormal temperature risen and so the projector was turned off. Please refer to
item “Check the status of projector” for the location of the sensors [A], [B] and [C], and temperature (+
p.39). Also see the owner's manual of the projector for further details.
* The Projector lamp was turned off, because the projector power circuit failed.
Unplug the projector from AC outlet and ask servicing to a qualified service personnel
* Replace it with a new lamp immediately and reset the lamp counter. If the projector is used without
reset the lamp counter, the alert mail is sent to users in every power-on of the projector.