Eiki MCD-100, Руководство пользователя

Страница: 46 / 96

46
8. Configuration with Browser
* Not displayed when wired LAN card is inserted to the MCI.
Parameter Description
Projector ..................................Name the projector(MCI) to distinguish it from others. (up to 32
characters). The name set here will be displayed on the main screen of
MCI client.
IP Configured Method ....................A desired IP address setup method is selected from [Manual], [DHCP],
and [BOOTP].
If [DHCP] or [BOOTP] is selected, the IP address is obtained
automatically as [DHCP client] or [BOOTP client]. At this time, it is
necessary that the DHCP server/BOOTP server must be in the
environment allowing the network communication.
When the IP Address Configuration Method is set to DHCP or BOOTP,
and you press the test switch to display the settings while the MCI is
attempting to obtain an IP address, IP Address, Subnet Mask, and
Gateway Address fields will display [-.-.-.-].
If the MCI fails to obtain IP address from the DHCP server, these fields
also show [-.-.-.-] and the MCI is not communicated. If the MCI fails to
obtain IP address from BOOTP server, the existing IP address will be
assigned.
IP Address ......................................Set the IP address in the environment you wish to use.
If [IP Configuration Method] is set to [DHCP] or [BOOTP], this setting is
not needed.
Subnet Mask ..................................Set the Subnet mask in the environment you wish to use.
If [IP Configuration Method] is set to [DHCP] or [BOOTP], this setting
may become unnecessary depending on the settings of [DHCP Server]
and [BOOTP Server].
Gateway Address ............................Set the gateway address in the environment you wish to use.
If [IP Configuration Method] is set at [DHCP] or [BOOTP], this setting
may become unnecessary depending on the settings of [DHCP Server]
and [BOOTP Server].
If any segment beyond the router is not used, the gateway address can
be remained “255.255.255.255”.
Wireless Mode* ..............................Set the wireless communication mode in the environment you wish to use.
Select either “Infrastructure” or “AdHoc”.
Channel*..............................................If you use the MCI in 802.11AdHoc mode, select the channel, from 1 to 11.
SSID/ESSID* ..................................Set the SSID/ESSID. (up to ASCII 32 characters)
SSID/ESSID is case-sensitive. Even though all characters projected by
pressing the TEST switch on Multi Card Director are uppercase, it is
necessary to distinguish between upper and lower case characters.
APPLY button ..................................If the contents you have set on this page are correct, click the [APPLY]
button. The screen to restart the MCI will be displayed. To enable your
new settings, click RESTART button.
REFRESH button ............................Cancel the new settings.
RESTORE Factory Default
Settings button ............Restore the settings to the values at the factory.