Edwards nEXT 55, Инструкция по эксплуатации

Страница: 68 / 116

The reply will be as follows:
Reply = S 8 7 1 sp d cr
5.1.10 Electronic braking options
Refer to Electronic braking on page 14 for a full description of the electronic braking
feature. To enable Electronic Braking, send the serial command that follows:
Command ! S 8 7 2 sp 1 cr
The reply will be as follows:
Reply * S 8 7 2 sp r cr
The state of the Electronic Braking option is stored in the memory of the pump.
To disable the Electronic Braking again, send the serial command that follows:
Command ! S 8 7 2 sp 0 cr
The reply will be as follows:
Reply * S 8 7 2 sp r cr
To check if electronic braking is enabled or disabled, send the query that follows:
Command ? S 8 7 2 cr
The reply will be as follows (where d=0 means disabled and d=1 means enabled):
Reply = S 8 7 2 sp d cr
5.1.11 Factory settings
The pump can be configured again to its original factory settings with one serial
command.
To reset the motor controller to factory settings, send the command that follows:
Command ! S 8 6 7 sp 1 cr
The reply will be as follows:
Reply * S 8 6 7 sp r cr
The factory settings are restored in the memory of the pump. If the valve type setting
was previously configured to a non-default setting, a Power cycle can be necessary.
5.1.12 Assigning a multi-drop address
Each individual pump must be programmed with its own multi-drop address through a
point
‑
to
‑
point connection before introduction into a multi-drop network.
When the pump is shipped, multi-drop mode is disabled by default.
To assign a multi
‑
drop address, send the command that follows (where the 'd' characters
represent the address):
Command ! S 8 5 0 sp d d cr
07/2021 - ©Edwards Limited Page 68 B8G000880_E
B8G000880_E - Configuration