Edwards nEXT 55, Инструкция по эксплуатации

Страница: 54 / 116

Object name
Command Parameter
range
Factory
setting
Data type Units
Comments
Analogue sig-
nal options
!S871 0 0 decimal - Analogue output = meas-
ured speed
?S871 1 - Analogue output = meas-
ured power
2 Analogue output = meas-
ured motor temp.
3 Analogue output = meas-
ured control temp.
4 Analogue output = meas-
ured rotor temp.
Electronic
braking op-
tions
!S872 0 0 decimal Electronic braking = disa-
bled
?S872 1 Electronic braking = ena-
bled. Refer to Electronic
braking on page 14.
Close vent
valve
!C875 1 - decimal - Closes the vent valve for
delayed start and over-
rides the current vent op-
tion. There is no open
vent valve command but
the stop command (!
C852 0) will clear the
override.
Valve 1 type !S877 0 0 decimal - Normally Open Valve
?S877 1 Normally Closed Valve
(power cycle is required)
Valve 2 type !S878 0 0 decimal - Normally Open Valve
?S878 1 Normally Closed Valve
(power cycle is required)
Service status ?V881 32 bits - hex flags Service status word
Controller run
time
?V882 0..999999 - decimal hours Hours run by controller
0..999999 decimal hours Hours until controller
service due
Pump run
time
?V883 0..999999 - decimal hours Hours run by pump
0..999999 decimal hours Hours until pump service
due
Pump cycles ?V884 0..65535 - decimal cycles Cycles run by pump
0..65535 decimal cycles Cycles until pump service
due
Bearing run
time
?V885 0..999999 - decimal hours Hours run by bearing
0..999999 decimal hours Hours until bearing serv-
ice due
07/2021 - ©Edwards Limited Page 54 B8G000880_E
B8G000880_E - Installation