Installation & User Guide
i-BOX Installation And User Guide_V4.2.6
Page 13 of 57
For network critical appliactions it is recommended that the i-BOX is connected to an
Uninterruptible Power Supply system (UPS system). In the event of a mains power failure the i-
BOX would draw it’s power from the UPS maintaining both access control and environmental
monitoring functionality.
User Cards or User Key Fobs
A variety of cards are supported:
Proximity
i-BOX key fobs, i-BOX proximity cards suitable for photo ID
The i-BOX controller supports up to 4,000 cardholders, 2,000 if used in conjunction with a pin code. The AX200
software supports up to a maximum of 65,535 cardholders.
Hardware Installation
1.
Install the i-BOX controller into the cabinet.
2.
Plug the 12v DC universal power supply into the power distribution strip mounted in the cabinet (in
accordance with current electrical regulations). Plug the DC jack end of the 12v DC universal power
supply into the power jack socket on the rear of the i-BOX.
3.
Install the i-PAL into the cabinet doors, ideally one handle into the front door and one handle into the
rear door in which the i-BOX is housed.
4.
Plug the i-PAL handle in to the “Access Control Point Connection” sockets on the rear of the i-BOX (see
fig 12.)
Fig. 12
Kalkenstraat 91-93 B-8800 Roeselare (Roulers) - Belgium
Tel. +32(0)51/25.06.10 Fax +32(0)51/24.02.57
Email: [email protected] website: www.rack19.be or www.eldeco.be or www.eldeco-edp.eu