EDM Solution 4+4, Руководство по установке, Страница: 77 / 174

Programming Domestic Reporting
Programming the control panel for domestic reporting has been made extremely simple by the
use of the Installer's Programming Command 965. Refer to "Command 965 - Set Up Domestic
Dialling Format" on page 27 for more information.
How To Set Up The Control Panel For Domestic Dialling
1. Enter Installer's Programming Mode (EG:
1234
followed by the button).
Two beeps will be heard and the STAY and AWAY indicators will begin to flash.
2. Enter Command
965
followed by the button.
Two beeps will be heard. The control panel has now been set up for Domestic Dialling
Format. Refer to “Command 965 - Set Up Domestic Dialling Format” on page 27 for
more information.
3. Exit Installer's Programming Mode by entering Command
960
followed by the
button. Two beeps will be heard and the STAY and AWAY indicators will
extinguish.
How To Program Domestic Phone Numbers
1. Enter your followed by
2
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
If there are telephone numbers programmed, they will be displayed one digit at a time
via the zone indicators on the codepad. Refer to "Table 26: Zone Indicators For
Changing Phone Numbers" on page 56 for the indicators and their meanings.
If there are no telephone numbers programmed, a further two beeps will be heard after
entering this mode. These two beeps are normally heard after the last digit of the last
phone number has been displayed.
2. Enter all the digits for , one digit at a time. You will notice as each digit is
entered, the corresponding codepad indicators will illuminate.
3. After you have entered all the digits of the first telephone number press the
button if there is more than one phone number. This will insert a break between the
first telephone number and the second telephone number. If there is only one phone
number, press the button to exit this mode.
4. Enter all the digits for , one digit at a time. You will notice as each digit is
entered, the corresponding codepad indicators will illuminate.
5. After the last digit of the second telephone number, press the button to exit this
mode unless a third telephone number is required.
Your control panel has now been set up to report in the domestic dialling format. Test
the dialling functions by triggering the control panel to report to your programmed
telephone numbers.
Dialler Reporting Formats 77
Electronics Design and Manufacturing Pty Limited ISSUE123.DOC