EDM Solution 4+4, Руководство по установке, Страница: 28 / 174

Command 966 - Enable/Disable Automatic Stepping Of Locations
This command enables or disables the automatic stepping of locations while programming.
When enabled via the hand held programmer, the decimal point of the left most display will
reflect the mode of operation.
If the decimal point is illuminated then auto step mode is active. An automatic increment of
the location being programmed will occur as soon as the
*
button is pressed positioning you
at the next location ready for programming.
If the decimal point is not illuminated, the auto step mode is disabled. The next programming
location will need to be manually selected by pressing the
#
button. As you can see from the
examples below, auto step mode is a very useful feature when programming successive
locations.
How To Enable Automatic Stepping Of Locations
1. Enter Installer’s Programming Mode.
(ie.
1234
followed by the
#
button).
2. Enter command
966
followed by the
#
button.
Two beeps will be heard.
How To Disable Automatic Stepping Of Locations
1. Enter command
966
followed by the
#
button.
Two beeps will be heard.
Example
(Auto Step Enabled)
To enter the Primary Telephone Number "02 pause 9672 1055" with auto step enabled (ie.
Decimal point illuminated).
Press
0
followed by the
#
button.
(This will position you at "LOCATION 000" being the start of the Primary Telephone
Number).
+
*
+
2
+
*
+ +
*
+
9
+
*
+
6
+
*
+
7
+
*
+
2
+
*
+
1
+
*
+ +
*
+
5
+
*
+
5
+
*
+
0
+
*
Example
(Auto Step Disabled)
To enter the Primary Telephone Number "02 pause 9672 1055" with auto step disabled (ie.
Decimal point extinguished).
Press
0
followed by the
#
button.
(This will position you at "LOCATION 000" being the start of the Primary Telephone
Number).
+
*
+
#
+
2
+
*
+
#
+ +
*
+
#
+
9
+
*
+
#
+
6
+
*
+
#
+
7
+
*
+
#
+
2
+
*
+
#
+
1
+
*
+
#
+ +
*
+
#
+
5
+
*
+
#
+
5
+
*
+
#
+
0
+
*
28
Solution 4+4
Installation Manual
ISSUE123.DOC Electronics Design and Manufacturing Pty Limited