Nexa™ Customer Service Reference Guide
January 2014 Page 3
CONFIDENTIAL
4. Installing unit with screws, anchors and tape
The dispenser is designed to match many of the screw holes of Ecolab’s and some
competitive dispensers. By positioning the dispenser appropriately on the wall, it may
be possible to use the previous anchor locations. For ADA compliance, mount between
15” and 48” off the ground. In order to comply with UL962, the TF dispensers are
required to be mounted using screws.
A. Clean and thoroughly dry the wall that the dispenser is to be mounted to.
Alcohol wipes work well for hard surfaces such as ceramic tile.
B. Use # 10 screws and appropriate anchors (use at least 2 screws to secure
the dispenser to the wall and space them out as far as possible).
C. Place the unit against the wall at the desired location. Using the holes on the
back of the dispenser as a template, mark the wall with a pencil or sharp
object (you must puncture the tape).
D. Use an appropriate size drill bit for the anchors, drill the holes.
E. Insert anchors into the holes.
F. Remove the protective backing on the tape that is affixed to the back of the
dispenser. Ensure proper location. Mount the unit at the desired location by
pressing unit against mounting surface.
G. Open the front cover and apply pressure to the back plate for at least 30
seconds to assure a good bond between the tape and the wall.
H. Insert the screws into the anchors.
MOUNTED WITH 2
SCREWS AND
WALL MOUNTS
MOUNTING HOLE
PATTERN